|
Overview
3RT10 contactors, 3-pole, sizes S00 to S3, up to 45 kW
AC and DC operation
IEC 60947, EN 60947 (VDE 0660)
The 3RT1 contactors are climate-proof. They are finger-safe according to EN 50274.
The 3RT1 contactors are available with screw terminals or with Cage Clamp terminals.
Size S00 contactors have an auxiliary contact integrated in the basic unit. The basic units of sizes S0 to S3 contain only the main circuits.
All basic units can be extended with auxiliary switch blocks. For size S0 and higher, complete units with 2 NO + 2 NC are available (connection designation according to EN 50012). The auxiliary switch block can be removed.
In addition, complete units with permanently mounted auxiliary switch block (2 NO + 2 NC according to EN 50012) are offered for sizes S00 and S0. These versions are built according to special Swiss regulations "SUVA" and are distinguished externally by a red identification plate.
The size S3 contactors have removable box terminals for the main conductor connections. This permits connection of ring terminal lugs or busbars.
Contact reliability
If voltages _ 110 V and currents _ 100 mA are to be switched, the auxiliary contacts of the 3RT1 contactor or 3RH11 contactor relay should be used as they guarantee a high level of contact reliability.
These auxiliary contacts are suitable for electronic circuits with currents _ 1 mA at a voltage of 17 V.
Short circuit protection of the contactors
For more information about short circuit protection of contactors without overload relay, see Technical Specifications. For more information about short circuit protection of the contactors with overload relay, see "Overload Relays". When installing fuseless motor feeders, the combinations of circuit-breakers and contactors described under "Fuseless Load Feeders" must be used.
Motor protection
3RU11 thermal overload relays or 3RB20 solid-state overload relays can be fitted to the 3RT1 contactors for protection against overload. The overload relays must be ordered separately.
Overvoltage damping
3RT1 contactors can be retrofitted with RC elements, varistors, diodes or diode assemblies (assembly of diode and Zener diode for short tripping times) for supressing opening surges in the coil.
The surge suppressors are plugged onto the front of size S00 contactors. Space is provided for them next to a snap-on auxiliary switch block.
For size S0 to S3 contactors, varistors and RC elements can be snapped on either on the top or directly below the coil connections. Diode assemblies are available in 2 different versions on account of their polarity. Depending on the application they can be connected either only at the bottom (assembly with circuit-breaker) or only at the top (assembly with overload relay).
The plug-in direction of the diodes and diode assemblies is specified by coding.
Exceptions:
3RT19 26-1T.00 and 3RT19 36-1T.00; the plug-in direction is indicated here with "+" and "-".
Coupling relays are supplied either without overvoltage damping or with a varistor or diode connected as standard, according to the version.
Note:
The OFF-delay times of the NO contacts and the ON-delay times of the NC contacts increase if the contactor coils are damped against voltage peaks (noise suppression diode 6 to 10 times; diode assemblies 2 to 6 times, varistor +2 to 5 ms).
For more information fell free to contact us:
Te : 03-89616713
Fax : 03-89616843
E-mail : elecont@streamyx.com
|
